LVM crush - Sheeted panels - Adjustable sides - Sheeted side panels

- Galvanised steel crush equipped with a ⧄ 60 mm reinforced frame,
- Double-leaved rear insemination gate with reversible operating handle at the top, accessible on the right or on the left,
- Factory-fitted non-slip mat on the bottom to prevent slipping and to limit noise,
- Slots under the crush so it can be moved either by forklift or via an optional 3-point hitch,
- Reinforced rotating connection rods welded to a mechanical tube with grease nipples,
- Retractable control handle for double-leaved rear gate,
- Retractable control handle for adjusting the inside width,
- Retractable control handle for the front PCCM gate,
- Movable sheeted end panels at the rear and movable rubber at the front to go with the adjustable sides.

This crush is equipped with a PCCM gate and has a road width of 3.15 m, but only if the following specifications are adhered to during travel:
- remove the extension arm with nose clip attachment from the PCCM gate and fold the baulk, Otherwise, you must add a signal kit to the crush, code PG1001117, which enables the signals on your hitch to be seen when the tractor lights are hidden.

- Fixed sheeted side panels with adjustable width at the bottom,
- Sheeted panels, removable and retractable at the top,
- Anti-backing system with blocking by a large bar.